DIY Colloidal Silver – How to Make Colloidal Silver at Home

The first step in making DIY colloidal silver is to purchase distilled water and a TDS meter. The water will turn yellow as the silver particles are absorbed into the solution. To avoid missing this step, set an alarm and wait for the water to turn amber. Then, pour the solution into a container. This is your final step. You can also choose to buy a TDS meter, or you can make your own at home.

You can also make your own colloidal silver at home by using two pieces of silver wire that are not connected to each other. The positive wire will release silver ions while the negative wire will produce bubbles. Use distilled water for this process. It will not corrode or taint your water. If you have saline in the bottle, it should dissolve in the water. Your DIY colloidal product should be cloudy and whitish. Afterward, you can use it to fight bacteria and viruses.

Do not attempt to make DIY colloidal silver at home. Doing so can be dangerous and should be done with caution. You will need a power source and water to conduct the process. Once the process is complete, you will need to strain out the silver particles and mix them with the water. Once the solution is ready, you should use it for your own use. As mentioned before, it is a simple process, but it is still not safe for your health. Aside from wasting precious time, you also need to ensure that you follow the manufacturer’s instructions.

A DIY colloidal silver kit will contain the components you need to create your own natural, homeopathic product. These parts will need to be connected to a power source and to the batteries. You will need three nine-volt batteries and some grips to make the final product. If you are attempting this procedure, you should not let the process overheat. And be sure not to add too much silver. The silver will be too concentrated.

The next step in making a DIY colloidal silver machine is to make a colloidal-silver generator. The device should be powered by three to four 9-volt batteries. It is possible to use less expensive batteries, but you should try to buy lithium-based ones. If you’re concerned about the purity of silver wire, use a gold-plated wire instead. You can also purchase silver bullion. But make sure you get pure silver wire and avoid the nickel.

DIY colloidal silver kits can cost as little as $8 per bottle, depending on the brand and potency. For a single bottle, you’ll need about eight to ten grams of 99.9% pure silver. You’ll need to find a reliable source of 999.9% pure sliver. It won’t cost a lot of money, but you can make a large batch and use it for a long time.